1. Directly select the post watering can for partial humidification until the humidity in the space reaches more than 50% before proceeding to the production operation of the pellet machine. Unless the humidity is above 50%, it is not recommended to start the production and processing of the machine when the humidity of the space is below 50%. The feed mixer should check the temperature and humidity thermometer placed next to the machine before grinding the pellets.
2. For feed mixer, it is strictly prohibited to use wet powder hammer, stainless steel bucket to bump the silo and machine silo of the pellet machine to prevent electrostatic sparks. When using the feed mixer, the operator must be equipped with “full-width arms” such as face masks, laundry gloves, anti-static underwear and special static-conductive shoes.
3. After grinding a bucket, transport a bucket quickly to prevent the accumulation of particles and cause high acetone concentration in the feed processing workshop. The feed mixer processing equipment generally uses a single pellet machine when grinding wet powder, and the wet powder bucket needs to be bucket by bucket. From the centrifuge room to the grinding room.
4. Before the feed mixer is put into production, it is necessary for the operator to check whether the electrostatic grounding device of the pellet machine equipment is fastened, and it is strictly forbidden to perform the operation of grinding wet powder.