When we use the feed pellet machine, sometimes there will be some small faults. Today we will do some brief analysis of the feed pellet machine failure, and also tell you some ways to eliminate the fault.
1. Low output
Causes of failure: 1. Poor finish of the die hole for the first time when the flat die is used; 2. The moisture content of the material is too high or too low; 3. The gap between the pressing roller and the flat die is too large; 4. The pressing roller or the flat die is severely worn; 5. Triangle The belt slips or ages.
Remedy: 1. Grind and lubricate with oily material, the output will increase after a period of work; 2. Adjust the moisture content of the material; 3. Adjust the compression bolt; 4. Tension or replace the V-belt
Second, the powder contains too much powder
Causes of failure: 1. Low moisture content; 2. Excessive flat die wear and excessive thickness.
Remedy: 1. Increase water content; 2. Replace with a new flat die.
3. The particles are rough
Causes of failure: 1. High moisture content; 2. Initial use of flat die.
Exclusion methods: 1. Reduce water content; 2. Repeat grinding with oily materials.
The above is the introduction of the causes and solutions of the common faults of the three feed pellet machines. I hope it will be helpful for everyone's daily use.