The third type: the motor is broken and the speed cannot be reached.
Many times, the motor on our feed mixer is broken, but it still rotates, and it looks fine, but in fact the speed has not reached the requirement for crushed corn. What to do at this time, teach you a trick to start the feed mixer , Don’t pour corn into the pit, put your hand on the feeding port, feel the suction of the wind is not strong, normal conditions can be sucked up with the palm of the hand, if this condition is not met, only a slight wind, then The motor is broken and needs to be repaired or replaced. I would like to remind you that it must be a self-priming type to test this way, and you must pay attention to safety.
Fourth: The rotor of the feed mixer is broken.
The rotor in the pulverizer is the core component. Once it has a large vibration, it means that the wear on it is too large, and sometimes it is not loaded. At this time, you can correct it or replace it.
In addition, there are some reasons such as: aging of the hammer, closed screen holes, and high water content of the crushed material (greater than 14%) will cause the machine to block or the conveying equipment is not matched, which will lead to no feeding.
The feed mixer can be equipped with an automatic feeding device, which can solve the problem of slow feeding or no feeding. The material is squeezed by double pressing rollers at the feed inlet, and the fluffy material enters the pressing roller to reduce the volume, and the material becomes dense and easier to crush.