Common failure one, the unloading door is not closed tightly
Generally, the unloading door is not closed tightly, mainly due to the jam of foreign objects.
Common fault 2: excessive vibration of the machine body during operation
Encountered such problems, mainly manifested in unstable installation and bearing wear. In this case, we need to re-install and replace the bearing.
Common fault three, there is a slight fatigue crack at the rivet hole of the pellet feed mixer
If there is a slight fatigue crack in the rivet hole of the feed mixer, the staff can use the whole unused new electrode to repair by welding, but the repair should be performed symmetrically with the axis of the impeller as the center, and the remaining electrode is repaired at the crack Stay here and use a new electrode to repair the symmetrical rivet hole cracks. The remaining electrode after welding is as long as the remaining electrode during symmetrical rivet repair, to ensure that the welding weight is flat.
Common failure four, the rivet head of the impeller of the feed mixer is worn
If the rivet head is worn out, the impeller body and the hub can be pressed tightly, and then welded by electric welding to restore the worn rivet head to its original normal state.
When encountering the above four types of failures, you can refer to the repair suggestions we provide. I also hope that these suggestions are helpful to everyone.